How to Lay a Patio in Garden

How to Lay a Patio

A patio is a space in your garden where you can invite guests to dine or do some recreational activities. It is every homeowner’s dream to have a patio in their courtyard. Not only does it add to the beauty of a home, but it is also very functional.

If you think it is difficult to learn how to lay a patio in your garden, think again. It just takes a few easy steps on how to lay a patio, and designing a patio in your backyard. But remember, you have to have all the necessary materials, tools, and equipment to succeed in its installation. You don’t want a patio that would not last. Most especially, you don’t want to reconstruct your patio over and over again just because it could not stand the test of time and the weather.

How to Lay a Patio Tip: Get All the Necessary Materials Ready

Of course, it would not be easy to start how to lay a patio without preparing the necessary building materials.

Here are the materials you need to complete the procedure on how to lay a patio:


  • Hardcore material
  • Building sand
  • Cement
  • Woburnrumbled paviours
  • Tools: wheelbarrow, rake, hammer, spirit level, plank of wood, cement mixer, wacker plate, rubber mallet, shovel, bolster chisel, wooden level pegs, pointing trowel.


Easy, Step-by-step Guide on How to Lay a Patio

By following this step-by-step guide on how to lay a patio, you will find yourself enjoying a relaxing afternoon in your backyard in a jiffy.

Step 1 on how to lay a patio is to clear the patio site. Take out all of the plants, weeds and other obstructions on the area you are planning to install your patio.

Next, set your patio 6-inch underneath the wet proof course. Excavate / Dig the soil about 6 inches deep. Make sure the soil is compacted. This gives room for the hardcore, mortar and paving slabs.

Dig and press down the hardcore base. Spread a good even layer of at least 4 inches of hardcore on the dug up area. Make room for the mortar, hardcore and slabs. Compact and make the hardcore even with the use of a wacker plate.

Lay your patio paving slabs. Tap down each of the slab with a rubber mallet. Consistently check if all slabs are leveled. Use wooden spacers to make the slabs gaps equal.

Last step on easy ways on how to lay a patio is to pave the slab joints. Once you are finished laying the patio, wait for a few days for the mortar to set in. Fill all of the joints with the mortar mix. Lastly, wash the paving slabs. Make sure it is clean of dirt. Make sure that there’s no spilled mortar on the slab surface. If there is, remove it immediately. Do not let it harden or else it will stain the patio.

And that’s all the things you need to learn on how to lay a patio. Now you can go ahead and plan on the design of your patio. Definitely, you don’t need a professional to do this easy guide on how to lay a patio.

Leave a Reply