Quick Ways on How to Lay a Patio

how to lay a patio

A backyard patio can be converted into your own little recreational area with friends and family. Inded, we all dreamed to have a patio in their courtyard. Not only does it add to the appeal of a house, but it is also very functional.

If you think it is hard to learn how to lay a patio in your garden, think again. It just takes a few easy steps to install and design a patio in the backyard. But remember, you need to have all the necessary materials, tools, and equipment to succeed in its installation. You don’t want a patio that would not last. Especially, you don’t want to lay your patio over and over again just because it succumbed to the wear and tear.

How to Lay a Patio Tip: Get All the Necessary Materials Ready

Obviously, you can’t start constructing a patio without preparing the necessary building materials.

Here are the materials you need to complete the procedure on how to lay a patio:

• Hardcore material

• Building sand

• Cement

• Woburn rumbled paviours

• Tools: shovel, rake, wheelbarrow, wooden level pegs, hammer, spirit level, plank of wood, wacker plate, cement mixer, rubber mallet, bolster chisel, pointing trowel.

Easy, Step-by-step Guide on How to Lay a Patio

By following this step-by-step guide on laying a patio, you will find yourself enjoying a relaxing afternoon in your garden in a snap.

First step is to clear the patio site. Take out all of the plants, weeds and other obstructions on the area you are planning to lay your patio.

Then, set your patio 6-inch below damp proof course. Dig out the soil to a depth of approximately 150mm or 6 inches. Ensure the soil is compacted. This gives room for the hardcore, mortar and paving slabs.

Dig out and compact a hardcore base. Spread a good even layer of a minimum of 100mm or 4 inches thick of hardcore over the excavated area. Leave room for the thickness of the slabs and mortar (about 30 to 50 mm or at least 2 inches). Use a wacker plate to compact and level the hardcore.

Lay your patio paving slabs. Tap each slab down using a rubber mallet and consistently check if they are well leveled. Use wooden spacers to guarantee equal gaps between slabs.

Last is to pave the slab joints. If you are done laying the patio, wait for a few days for the mortar to set in. Fill joints with a dry mortar mix. At the end of the day, wash down the slabs and wash it of dirt. Make sure you do not spill mortar on the slab surface.

And that’s about it. Now you can go ahead and research on patio design. Definitely, you don’t need a professional to do this easy guide on how to lay a patio.




Leave a Reply

*